Reboot and Select proper boot device error is a critical hardware error. Basically, this error will show up when your personal device BIOS is having some problem looking for the other bootable devices. If you are a frequent user of Windows 10 you might receive an error message about Reboot and Select Proper Boot Device. If you are tensed about this error, then we have some good news for you. In this article, we will provide complete guidance on how to fix this problem in a jiffy.
Top Solutions To Fix Reboot And Select Proper Boot Device
At first, you must learn how to change the boot order. Here is what you have to do.
First of all turn off your computer by pressing the power button to boot it. Now, go to the BIOS setting by pressing the appropriate button. However, we advise you to go through your device’s user manual to find the right key. Generally, we use F2, ESC, F12 or delete key. After all the changes are done, restart your computer.
Step 1- Check and Fix The Problems
As we have described the issue may arise from your system’s OS drive. First of all, you check that your SDD and HDD cable is correctly connected with your personal system or not. You can easily fix it by yourself. Follow these steps-
- Turn off your PC.
- Press the appropriate key and go to the BIOS settings. Read your System’s manual to know the proper key for the save change of BIOS settings.
- After the modification in the BIOS settings, go to the Main settings or Standard CMOS option.
- Now, make sure that your computer’s SDD or HDD is mentioned on this page.
If you notice that your systems are not listed in the BIOS setup, then it is sure that your SDD and HDD are not connected properly with your system. The cables may be the main cause of this issue.
Step 2- Use The Diskpart
‘Reboot and Select Proper Boot Device’ error message can arise if the system’s active drive is not configured with the primary hard drive. Follow these steps and fix this problem.
Reboot your device and boot it from media features. Select the Troubleshoot option after opening the System Recovery menu. Now, click on the Advanced Option which is under the Troubleshoot section. Select the Command Prompt which is under the Advanced Options menu. Go to the Command Prompt Search box and type ‘diskpart’ and then press Enter from your keyboard.
Write the mentioned command and press the Enter after every command.
‘Select partition x’ ( *Change x to the number of your primary partition*)
Step 3:- Change CMOS Battery
If this cell is broken or damaged anyhow, it will be the main cause of this issue or another issue. Open your devices casing and access the motherboard to replace the CMOS battery. Check that you get rid of any excess charge by pressing the power button for a few seconds. Thereafter, change the CMOS battery with the another. Now check that your error message is still showing or not. If you are facing the same problem again then follow the next step.
Alternative Way- Clean Your Device’s RAM
If the RAM on your device is messy then the device shows this type of error message. Clear the dust on the RAM with a soft cloth and check if the error message continues or not.
After solving the error related problem then clean your Windows registry. This will confirm that there are no any damaging files.
We hope that after using all the above steps your problem has been solved.